FiltersDone

Question type

Essay

Multiple Choice

Short Answer

True False

Matching

Exam 7: Routing Protocols

Show Answer

Share

---

All types

Filters

Study FlashcardsPractice ExamLearn

Question 21

Multiple Choice

Review LaterAdd Note

Review Later

An autonomous system (AS) uses ____ as routing protocols.

A) Exterior Gateway Protocols
B) Border Gateway Protocols
C) Limit Gateway Protocols
D) Interior Gateway Protocols

E) C) and D)
F) All of the above

Correct Answer

verified

Show Answer

Question 22

Essay

Review LaterAdd Note

Review Later

What are the metrics that can be configured for IGRP?

Correct Answer

verified

IGRP does not use hops as a metric by de...

View Answer

Show Answer

Question 23

Essay

Review LaterAdd Note

What is administrative distance?

Static routes are configured by a network administrator using the ____ command.

Early networks were sometimes configured as ____________________ networks, in which computers communicate with and provide services to their "peers."

Peer-to-peer networks pass packets between multiple networks.

When IP routing is enabled, you can use the ____ command or the ip route 0.0.0.0 0.0.0.0 command to configure a default route.

Routers configured with a link-state routing protocol use ______________________________ to inform neighbor routers on the internetwork.

You use the ____ command to display the routing table.

A ____ route is a type of static route that the administrator configures.

____________________ is a state where all routers on the internetwork share a common view of the internetwork routes.

____ are often referred to as count-to-infinity problems because loops, without preventive measures, will cause packets to bounce around the internetwork infinitely.

____ controls what information a router will send out through a particular interface.

Networks with one route to the Internet are called ____.

How can you change a route administrative distance?

____, which are the packets used to send out LSAs, allow every router in the internetwork to share a common view of the topology of the internetwork.

How can you configure a default route?

____ protocols have packet headers that can contain Network layer addresses.

The Cisco ____ command turns on RIP routing for a network.

Routers use metrics to determine which routes are better than other routes.